Leaning Chimney or Gap at the Wall? What Romeoville Homeowners Should Know

By James Rodriguez, Central Chimney Service.

A chimney that leans or pulls away from the house is almost always a footing or settlement problem, not a mortar problem, and it should be looked at before winter. A hairline gap that grows over a few seasons can let water into the wall, strain the flashing, and in bad cases put the flue out of alignment with the firebox or furnace connector.

Exterior chimneys on many Romeoville homes sit on their own concrete footing, separate from the house foundation. When that footing is too small, too shallow, or the soil beneath it gets saturated, the chimney can settle at a different rate than the house. After 29 years inspecting chimneys around Will County, this is one of the repairs I most want homeowners to catch early. If you live in town, our Romeoville chimney sweep and repair page covers the neighborhoods we serve.

How can you tell if a chimney is leaning?

Look for a gap between the chimney and the siding or brick of the house, usually wider at the top than at the bottom. Other signs include caulk that keeps tearing at that seam, cracked mortar in a stair-step pattern near the base, and flashing that has pulled loose on the roof.

From the ground, stand at the corner of the house and sight up the chimney against a straight edge of the wall. Even a slight tilt is easier to spot this way than from straight on.

What causes a chimney to separate from the house?

The most common cause is an undersized or shallow footing. Others include downspouts that dump water at the chimney base, poor grading that sends water toward the foundation, and repeated freeze-thaw cycles working on saturated soil. Heavy clay soil, common across the southwest suburbs, holds water and moves as it wets and dries.

Is a leaning chimney dangerous?

It can be. A small, stable gap is mostly a water-entry problem. A gap that is growing means the structure is still moving, and a chimney that keeps tilting can crack its flue liner, break the seal at the roof, or pull away far enough to become a falling hazard in high wind. Do not use the fireplace or wood stove until the chimney has been inspected if you see new movement.

What does the inspection involve?

We inspect to NFPA 211, the chimney standard we follow. For movement like this we look at the footing area, the exterior masonry, the roof flashing, and the flue interior. A camera scan of the flue shows whether the liner has cracked or offset. NFPA 211 calls for a Level 2 inspection after an operating malfunction or event that may have damaged the chimney, and structural movement is exactly that kind of situation. Details are on our chimney inspection page.

How is a leaning chimney repaired?

The fix depends on how far it has moved and whether it is still moving:

  • Small, stable gap — repoint cracked joints, reseal the seam with a proper masonry sealant, and rework the flashing.
  • Active settlement — the footing has to be stabilized first. That is foundation work, often done with piers, and we will tell you plainly when you need a foundation contractor.
  • Severe lean above the roofline — the upper section may need to be taken down and rebuilt plumb.

Sealing a gap on a chimney that is still moving just hides the problem until the caulk tears again.

What can you do right now?

Extend downspouts so water lands several feet from the chimney base, fix any grading that slopes toward it, and take a dated photo of the gap with a tape measure in the frame. Re-photograph it in a month. That simple record tells an inspector whether the movement is active.

Call us before the first hard freeze

Central Chimney Service is insured and bonded, and we give you the price up front. See our chimney repair services and current rates on the pricing page. Call (815) 305-5510, 7 days a week, 7 AM–7 PM.

Frequently asked questions

Why is my chimney pulling away from my house?

Usually because the chimney’s footing is settling at a different rate than the house foundation. Undersized footings, water at the base, and clay soil are the common causes.

Is a gap between my chimney and siding normal?

No. A tight seam is normal, but a visible gap, especially one wider at the top, means the chimney has moved and should be inspected.

Can I just caulk the gap?

Only if an inspection confirms the movement has stopped. Caulking a chimney that is still settling hides the problem until the seal tears again.

Should I stop using my fireplace if the chimney is leaning?

Yes, if the gap is new or growing. Movement can crack or offset the flue liner, so have the chimney inspected before the next fire.

What inspection level does a leaning chimney need?

NFPA 211 calls for a Level 2 inspection after an event or malfunction that may have damaged the chimney. Structural movement fits that description and includes a camera scan of the flue.

Can a leaning chimney be straightened?

Not usually by pushing it back. The footing is stabilized first, and a section above the roofline that is badly out of plumb is typically rebuilt.

How do I know if the chimney is still moving?

Photograph the gap with a tape measure in the frame, note the date, and photograph it again a month later. Any change means the movement is active.

Do you inspect leaning chimneys in Romeoville?

Yes. Call Central Chimney Service at (815) 305-5510, 7 days a week from 7 AM to 7 PM. We are insured and bonded and quote the price up front.

Published November 1, 2026

About·Services·Pricing·Service Areas·Contact·Newsletter·Privacy Policy
Central Chimney Service — 12800 S Route 59, Plainfield, IL 60585
(815) 305-5510 · Open 7 days a week, 7am–7pm · Insured & Bonded
Add Central Chimney Service as a Preferred Source on Google
© 2026 Central Chimney Service. Serving Plainfield & the surrounding area.
↑
Scroll to Top